SerialPort

Instances of this interface may be obtained by calling methods of the Serial interface, therefore it has no constructor of its own.

SerialPort.readable Read only Experimental

Returns a ReadableStream for receiving data from the device connected to the port.

SerialPort.writable Read only Experimental

Returns a WritableStream for sending data to the device connected to the port.

SerialPort.forget() Experimental

Returns a Promise that resolves when the port closes and is forgotten.

SerialPort.getInfo() Experimental

Returns an object containing properties of the port.

SerialPort.open() Experimental

Returns a Promise that resolves when the port is opened. By default the port is opened with 8 data bits, 1 stop bit and no parity checking.

SerialPort.setSignals() Experimental

Sets control signals on the port and returns a Promise that resolves when they are set.

SerialPort.getSignals() Experimental

Returns a Promise that resolves with an object containing the current state of the port's control signals.

SerialPort.close() Experimental

Returns a Promise that resolves when the port closes.

connect Experimental

An event fired when the port has connected to the device.

disconnect Experimental

An event fired when the port has disconnected from the device.

Before communicating on a serial port it must be opened. Opening the port allows the site to specify the necessary parameters that control how data is transmitted and received. Developers should check the documentation for the device they are connecting to for the appropriate parameters.

await port.open({ baudRate: 9600 /* pick your baud rate */ });

Once the Promise returned by open() resolves the readable and writable attributes can be accessed to get the ReadableStream and WritableStream instances for receiving data from and sending data to the connected device.

The following example shows how to read data from a port. The outer loop handles non-fatal errors, creating a new reader until a fatal error is encountered and readable becomes null.

while (port.readable) {
  const reader = port.readable.getReader();
  try {
    while (true) {
      const { value, done } = await reader.read();
      if (done) {
        // |reader| has been canceled.
        break;
      }
      // Do something with |value|…
    }
  } catch (error) {
    // Handle |error|…
  } finally {
    reader.releaseLock();
  }
}

The following example shows how to write a string to a port. A TextEncoder converts the string to a Uint8Array before transmission.

const encoder = new TextEncoder();
const writer = port.writable.getWriter();
await writer.write(encoder.encode("PING"));
writer.releaseLock();